DIGITAL IMAGING
DIGITAL IMAGING
A cylinder-like mounting system that is used with rigid materials such as Sintra or acrylic. The stand-off is anchored to the wall and holds the material a prescribed distance from the wall. Typically aluminum, it is available in a variety of sizes, lengths and shapes. MDC’s standard sizes: 3/4” & 1” diameter; 1/2”, 1” & 1.5” off the wall.
Similar to a stand-off, a cable suspension system attaches to the printed material using a cylinder-like device - but instead of anchoring to the wall, the cylinder attaches to a cable. The cable can be attached to the wall, ceiling and/or the floor. The cable can also be attached directly to the display piece without the mounting cylinder.
A theft deterrent mounting system used for Sintra and framed art panels that uses a series of clips and a locking screw to attach the design to the wall.
The design is wrapped around a panel/frame. A typical application would be acoustical panels or office partitions and unframed art.
This system has a pole pocket on the top and bottom which is closed. The top is slotted to allow access to hanging system. The material is usually vinyl.
This system has a pole pocket on the top and bottom which is closed. The top is slotted to allow access to hanging system. The material is usually vinyl.
A mounting system that uses two opposing pieces - one attached to the design, one to the wall. With a recessed cleat, the half attached to the design is recessed so that the back of the graphic is flush with the wall once installed.
A simple brass or silver grommet that is embeded into all four corner and if necessary grommets on the sides.
